Its contest time!
The new contest is a really interesting one, and is a golden opportunity for those who love designing beys, but don't have printing services.
So, get your pencils and creativity ready, because we are going to have the first ever IBA BEY DESIGN CONTEST!!!
The rules are quite simple.
1. The participants have to design the mascots beys.
2. It doesn't have to be a complete design, but it's preferable if it is.
3. They have to give the name of the bey, parts and the beys gimmick. The gimmick should not be outworldly, and should be possible to fit into a bey.
4. A simple drawing of the bey is a must. If you're not good at drawing, they can get help from someone else, who are good at drawing.
5. Out of the designs we get, the best 2 will be chosen.
6. The names of the beys have to start with S or V.
7. It has to be a dual layer burst bey.
The prize is the 3D printed model if your bey!!!
Therefore, get ready!
To Enter Either Upload Your Clean Concept on Instagram or Youtube with #IBABEYDESIGNCONTEST AND #INDIANBEYBLADEASSOCIATION and link your post in comments on this thread. Alternatively Post them here directly.
For Help Ask Me, @FIREFIRE CPB @Mohith0412
Wanna be simple
Name: Ferocious Draco King Spike
Layer: Ferocious Dragon
Dual spinning layer, mode changes right to left like Spriggan Requiem
Disk: King
Nothing Special just two small kings sword on its side
Driver: Spike
To be specific it's like WD from mfb but has four small spikes on its side as shown
Overall the Bey is fit as a dual layer
@IndianBeyBladeAssociation
#INDIANBEYBLADEASSOCIATION
#IBABEYDESIGNCONTEST